(please note: they have a very tight fit by design. To connect one module to another print also 4x PIN Connector. The Top Cover comes into two styles: one simpler, easy and fast to print, and another a little more complex, called decorative, which resembles a protection grid. In order to assemble a single "module" you will need to print the following:
They are designed for a tight fit, but if you need to push the whole assembly down a long PVC Tube you might want the extra safety knowing you can pull it out in one piece all the times you need. Modules can also be assembled "continuously" using the PIN Connector which allows two PINs to be joined together, by leaving the respective PIN from each module protruding at the extremities.Įxample photos/video shows a standard polyethene air filter being cut and stacked to realize the filter: I needed that kind of filter for my scenario, it is not intended to be a limiting factor on the possible usage.įor tight fits and/or permanent installation, I recommend applying a little dab of superglue at PIN's extremities. Modules can be simply assembled separately and then stacked together inside the tube, or the connecting PIN can be scaled up to realize a single, thicker unit. The design is modular: one can print-and-stack as many "units" as needed, eventually changing or alternating filter material as per needs. allowing to use any material to act as a proper filter using as little filament as possible, without the need for supports or long printing times Ģ. I designed this modular system to create a versatile "air filter" that could fit into virtually any PVC round tube section.ġ.
0 kommentar(er)
